The product is mainly used as a guiding mechanism for feeding linear material onto a rotating reel during the winding process, where one rotation of the reel requires a traverse movement equal to one diameter of the material being wound.
A solid one-piece housing with fixed, load carrying bushings fitting onto the shaft.
A driving system independent of the housing.
115 150 POST-TYPE AIR WIPE
【Model 115 150 POST-TYPE AIR WIPE】
Two variants of this product provide large capacity and highly efficient air wipes for use with cables and extruded materials up to a maximum diameter of 150mm.
The design features:
a) Automatic opening for ties, clamps or knots
b) Adjustable air discharge slits
c) Adjustable post position to accommodate
alternative cable sizes
d) Cable support roller
688 674 685 Adjustable Orifice Air Wipe
【Model 688 674 685 Adjustable Orifice Air Wipe】
The three high efficiency air wipes in this series are suitable for wires from 2mm to 65mm diameter.
Their design features:
a) An adjustable orifice diametercalibrated for ease
b) Low noise levels at high wiping efficiency
c) Automatic opening for knots
d) Left or right hand operation
838 High Speed Air Wipe
【Model 838 High Speed Air Wipe】
The air wipe is designed for the removal of water and other low viscosity liquids from cables and bare or coated wires up to 8mm diameter at line speeds up to approximately 1000 metres/min.
The Chalker-4 will apply a light dusting of powder onto the surface of insulated cables, hoses or profiles during a rewinding or extrusion process.